Jump to content

bmwtom

Members
  • Content Count

    22
  • Joined

  • Last visited

About bmwtom

  • Rank
    Member
  • Birthday 27/08/1981

Profile Information

  • Current Car
    e46,325i convertiable
  • Gender
    Male

Recent Profile Visitors

993 profile views
  1. hi kirkynut no i don't think i did lol , but the motor parts place sold me the wrong oil for the auto box so drain it out and put 4 litres of the correct oil in it , think i might still need to top it up as took it back out today and it was a bit better but when i plugged the laptop in and checked the error codes for the auto box it came up with , pressure controller eds 1 , pressure controller eds 2 , pressure controller eds 3 , pressure controller eds 4 and gear check 4 , i don't suppose you would happen to know what these mean at all , thanks for the help
  2. hi guys i have a problem i recently broughta e46 325i convertible the bloke told me that the auto gearbox sump gasket was leaking so i drained the old fluid out then put a new filter in and filled it up with atf fluid , so i took it out for a little drive to see if every thing was ok it drove fine then i felt it jolt then i losed all forward gears and the cog symbol came on on the dash so i pluged it in to my laptop and thisis what it brought up any help woud be much appreciated . 2019-04-16_184839.pdf
  3. Hi guys I have the same problem I have a saloon were would the fzv antenna be on the saloon
  4. Hi I'm looking to swap my instrument panel over for the m3 one has any one done it be for I have a 320 se saloon and quite like to put the m3 one in there
  5. OK not sure if putting back on yet but thanks guys only put them on cause the heat under the bonnet is there any other way of getting the heat out
  6. Hi not sure if this is the right place but has any one put bonnet spacers on their e46 I put 12mm on mine and my indicators stopped flashing when I locked it and when I took them off they worked again is there any way around it at all .
  7. bmwtom

    E46 swap

    Hi I have a e46 saloon I'm looking to do a straight swap for either a coupe or a convertible pics to follow
  8. Hi what would cause the cooler outlet temp to be around 120-140 and what would cause this error 4/ nw-e-error also says (engine state - over run shut) not sure what is coursing cooler outlet to be this hi and what would cause the engine to keep cutting out when slowing down my engine is a m54 2.2
  9. I've just pluged my 320 in to inpa and its thrown up 4 errors not sure what these ones are any help given would be grateful 1/ cooler outlet also says (ubatt or open circuit) current temp on this is 120-140 when it should be under 90. 2/ lambda probe heating downstream sensor 1 it says on this one that( cat-senor heater defective) 3/lambda probe voltage downstream sensor 1 also says (open circuit) 4/ nw-e-error also says (engine state - over run shut off) Would lambda sensor need replacing not sure what is coursing cooler outlet to be this hi and error number 4 as engine keeps cutting out when slowing down and where would number 1lambda sensor be my engine is a m54 2.2
  10. I've just pluged my 320 in to inpa and its thrown up 4 errors not sure what these ones are any help given would be grateful 1/ cooler outlet also says (ubatt or open circuit) current temp on this is 120-140 when it should be under 90. 2/ lambda probe heating downstream sensor 1 it says on this one that( cat-senor heater defective) 3/lambda probe voltage downstream sensor 1 also says (open circuit) 4/ nw-e-error also says (engine state - over run shut off) Would lambda sensor need replacing not sure what is coursing cooler outlet to be this hi and error number 4 is engine keeps cutting out when slowing down and where would number 1lambda sensor be my engine is a m54 2.2
  11. hi i have inpa with ncs expert i was looking to change some bits on the car key memory not sure how to work it does any one on here know at all cheers
  12. hi any one know were i can get a vorsteiner gt-r racing bonnet and gts3 front lips tried website but know joy
  13. hi not sure if this is the right place has anyone put a oil catch tank on a m54 engine
  14. my mate ragtop steve pluged it on his machine and it came up with sterring angle sensor internal fault as i have already done the occupancy by pass
  15. my air bag light is on i have been told that it is the steering angle sensor were abouts is it on the steering column also is there any one in salisbury that can recalibrate the sensor at all . cheers tom
×
×
  • Create New...