Steve330ci Posted January 11, 2020 Report Share Posted January 11, 2020 (edited) Hello, New member with a question. just swapped the front hub and bearing over on my 330ci. I have read to tap it onto the stub axel then use the nut to wind it on then torque the nut upto 290nm. My question is by doing this will the bearing have been pushed up the stub far enough and seated properly by torquing the nut. The Outer face of the nut ended up flush with the end of the stub axel so you can seal the nut on. just want to make sure it is on correctly etc. many thanks. Edited January 11, 2020 by Steve330ci Quote Link to comment Share on other sites More sharing options...
Steve330ci Posted January 11, 2020 Author Report Share Posted January 11, 2020 1 hour ago, Steve330ci said: Hello, New member with a question. just swapped the front hub and bearing over on my 330ci. I have read to tap it onto the stub axel then use the nut to wind it on then torque the nut upto 290nm. My question is by doing this will the bearing have been pushed up the stub far enough and seated properly by torquing the nut. The Outer face of the nut ended up flush with the end of the stub axel so you can seal the nut on. just want to make sure it is on correctly etc. many thanks. Quote Link to comment Share on other sites More sharing options...