Gravy Posted May 24, 2015 Report Share Posted May 24, 2015 What is the best way to fit these splitters anyone done a guide? I will be doing it myself, I believe there is 3 screws (don't have splitters as yet en-route) on each, but want them to look bang on perfect, no gaps etc. Is it a two people job, one to line up and hold the splitter in situ and the other screw it in? What are the best screws to us, as mine will not come with them Cheers Chaps. Link to comment Share on other sites More sharing options...
Chimp Choker Posted May 24, 2015 Report Share Posted May 24, 2015 Mine came with 3M tape and I just put a few self tappers in for good measure no drama on fitting Nimraynn, Gravy and Daud 3 Link to comment Share on other sites More sharing options...
pirate1066 Posted May 24, 2015 Report Share Posted May 24, 2015 Warm them up before you fit helps get a snug fit Gravy 1 Link to comment Share on other sites More sharing options...
JasonK Posted May 24, 2015 Report Share Posted May 24, 2015 Warm them up before you fit helps get a snug fit Bang on. I warmed mine up until they were flexible, fitted with the tape and 3 screws in the bottom. Then used some black mastic to seal around the top to stop water getting behind, and smooth out the small, but inevitable, gaps in places. In my opinion it looks spot on, and I suspect is the fit you are looking for! Gravy 1 Link to comment Share on other sites More sharing options...
Gravy Posted May 24, 2015 Author Report Share Posted May 24, 2015 Thanks gents Link to comment Share on other sites More sharing options...
Daz 330 Cs Posted May 25, 2015 Report Share Posted May 25, 2015 As above, double sided tape along the top edge, then a couple of self tappers from underneath. This is how they're fitted at the factory. Link to comment Share on other sites More sharing options...
